Installing rear retaining strip (rear section)
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten nuts -2-
to > Tightening torque 9.7 (7.5 ftlb.) Nm
.
Tighten screw -1-
to > Tightening torque 2 (1.5 ftlb.) Nm
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Rear retaining strip (rear section)