Installing Rear Bumper
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Always replace self-locking nuts and screws.
Information
- There must be no underbody protection, sealing material or wax at the screw-on points.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws to > Tightening torque 40 (30 ftlb.) Nm .