Disassembling Front Apron (Turbo)

Information 

• The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment. 

• The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant. 
• Some steps must be carried out automatically. 
• Some of the repair illustrations show only one side of the vehicle. 

1. Remove number plate cover.

   > *** 668319 Removing and installing number plate cover

2. Remove front wire harness.

   > *** 971519 Removing and installing front wire harness

3. Only for USA vehicles: 

   Remove side marker light.

   > *** 942755 Replacing light bulb for side marker light

4. Remove auxiliary headlights.

   > *** 947119 Removing and installing auxiliary headlights

5. Remove radiator grille.

   > *** 660519 Removing and installing radiator grille

6. Remove ParkAssist sensors.

   > *** 917519 Removing and installing ParkAssist sensor

7. Remove front spoiler.

   > *** 660319 Removing and installing front spoiler

8. Unclip side vane -1-  at the locking lugs -2-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Side vane

9. Remove expanding clip -1-  and remove reinforcement -2-  from the front apron (Turbo).

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Reinforcement

10. Unclip holder for ParkAssist sensor -1-  at the locking lugs -2-  .

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Holder for ParkAssist sensor

11. Unclip trim -3-  at the locking lugs -4-  .

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Cover

12. Unclip cover on towing lug -1-  and guide out the bracket -2-  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cover on towing lug