Installing Front Apron
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws on top of front apron at the centre to > Tightening torque 8 (6 ftlb.) Nm .
Tighten screws on top of front apron at the sides to > Tightening torque 2 (1.5 ftlb.) Nm .
Tighten screws for front apron in the wheel housing to > Tightening torque 2 (1.5 ftlb.) Nm .
Tighten screws securing front apron to lower lock carrier to > Tightening torque 2 (1.5 ftlb.) Nm .