Installing Moulded Hose (Turbocharger - Charge Air Cooler)
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten the screw clamp of the moulded hose on the turbocharger.
- Tightening torque 5.5 Nm (4 ftlb.)
- 1.2
Tighten screw-type clamp on moulded hose for charge air cooler right.
- Tightening torque 5.5 Nm (4 ftlb.)
- 1.1
Tighten the screw clamp of the moulded hose on the turbocharger.