| Air inlet housing cover to body |
Hexagon nut |
Tightening torque |
3.5 Nm (2.5 ftlb.) |
|
|
| Mounting saddle to spring strut (PASM only) |
M8 thread |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Mounting saddle to body |
M10 x 35 thread/observe specified tightening sequence/always use new screws or bolts following removal |
Initial tightening |
40 Nm (30 ftlb.) |
|
|
| Mounting saddle to body |
M10 x 35 thread/observe specified tightening sequence/always use new screws or bolts following removal |
Final tightening |
+ 90° |
|
|
| Air line to air-spring strut |
|
Tightening torque |
3 Nm (2 ftlb.) |
|
|