Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Screws for coolant pipes |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Upper screws on chain housing cover in chain box |
Replace following removal. |
Tightening torque |
8 Nm (6 ftlb.) |
|
|
| Upper screws on chain housing cover in chain box |
Replace following removal. |
Final tightening |
+ 90° |
|
|
| Screw for lower chain housing cover |
M6 x 25 (19ea.)/replace aluminium screws with steel screws, observe specified tightening sequence |
Initial tightening |
3 Nm (2 ftlb.) |
|
|
| Screw for lower chain housing cover |
|
Final tightening |
+ 90° |
|
|
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Double screw for additional coolant pump (turbocharger) |
M6 x 14/M6 x 14 |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screws securing additional coolant pump (turbocharger) to holder |
|
Tightening torque |
1.5 Nm (1 ftlb.) |
|
|
| Screws for coolant pipes |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Fastening screw for high-pressure fuel line |
Replace |
tightening torque |
8 Nm (5.9 ftlb.) |
|
|
| Fastening screw for high-pressure fuel line |
|
final tightening torque |
+ 45 Nm (33.2 ftlb.) |
|
|
| Union nut for fuel line |
Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. |
tightening torque of |
10 Nm (7.4 ftlb.) |
|
|
| Union nut for fuel line |
Coat thread on union nut with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. |
Torque angle |
60° |
|
|
| Screw for chain housing cover on cylinder bank 1 |
M6 x 22 (8ea.)/replace, observe specified tightening sequence |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw for chain housing cover on cylinder bank 2 |
M6 x 22 (7ea.)/replace, observe specified tightening sequence |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|