Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link to spring strut | Item 2: M10 x 45 thread/Always replace bolts following removal | Final tightening | + 90° | ||
| Level sensor to lower trailing arm | M6 thread | Tightening torque | 9 Nm | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° | ||
| Upper trailing arm to wheel bearing housing | M10 thread | Tightening torque | 45 Nm | ||
| Damper fork to damper | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | 90 Nm (66 ftlb.) | ||
| Damper fork to damper | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 90 Nm (67 ftlb.) | ||
| Connecting link to spring strut | M10 x 45 thread/always use new screws or bolts following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Tie-rod ball to wheel carrier cone | M12 x 1.5 thread/always use new nuts following removal | Tightening torque | 100 Nm (74 ftlb.) |