Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Upper trailing arm to wheel bearing housing | M10 thread | Tightening torque | 45 Nm | ||
| Upper trailing arm to mounting saddle | M10 thread/always use new screws or bolts and nuts following removal | Initial tightening | 50 Nm | ||
| Upper trailing arm to mounting saddle | M10 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° |