Before Starting Suspension Alignment: Prerequisites
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Perform suspension alignment using an electronic wheel-alignment analyser. Measurement procedures are described in the operating instructions for the wheel-alignment analyser used.
For nominal value for front and rear axles, refer to the technical data.
> 4495TW - ADJUSTMENT VALUES FOR SUSPENSION ALIGNMENT
- Empty weight of vehicle according to DIN 70020, i.e. vehicle in ready-to-drive condition with full fuel tank and including tools but without driver or additional weights.
- Joint and wheel-bearing play OK (wheel-bearing play cannot be adjusted). Check joint play if necessary.
> Refer to 0X03IN - Running gear maintenance: Checking ball joints/bellows in the appropriate service information
- The tread depth on one axle must not differ by more than 2 mm.
- Tyre pressure in accordance with specifications
- Strictly comply with maintenance intervals for measuring equipment and measuring platform.
- Perform suspension alignment only in the sequence specified in the appropriate service information.