Installing Pressure Sensor

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Toxic substances

Danger of poisoning or suffocation
Danger of burns to the eyes and skin
1. → Ventilate the work area well.
2. → Never ingest or inhale.
3. → Read specific information on the Hazard Sheet.
4. → Wear personal protective gear.
5. → Do not smoke, eat or drink in the work area.

WARNING: Highly inflammable or explosive materials

Danger of fire or explosion
1. → Avoid contact with hot parts or sources of ignition.
2. → Use suction to remove ignitable vapours.
3. → Attach warning sign in a clearly visible position.
4. → Contain leaked media using non-flammable absorbent material and put it in a container designed for this purpose for disposal in accordance with local requirements.
5. → Secure collection containers/vessels to prevent them from tipping over.

WARNING: Leaking fuel supply lines

Emerging fuel
Risk of fire
1. → Perform leak test.

Information

Coat thread of the pressure sensor with Microgleit DF 977 S. Observe drying time of at least 5 minutes before fitting.

Install pressure sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressure sensor
1. 1.1 Coat thread of pressure sensor -1- with a tight coating of Microgleit DF 977 S.
2. 1.2 Screw in and tighten pre; sure sensor -1- .
3. 1.3 Connect and lock cable plug -4-