Installing Front Air-Spring Strut

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:

Fig 1: Body Mounting Saddle Screws Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence for mounting saddle to body
1. 1.1 Replace screws securing mounting saddle to the body -1 to 4- .
2. 1.2 Tighten screws securing mounting saddle to the body in the sequence -1 to 4- .
  > Initial - tightening 40 Nm (30 ftlb.)
  
  > Final tightening + 90°
3. 1.3 Only for removing front right spring strut:
  Tighten nuts on air inlet housing cover.
  
  > Tightening - torque 3.5 Nm (2.5 ftlb.)