Installing Control Unit For Steering Wheel Electronics

Airbag contact unit not set correctly 

• Malfunction in driver's airbag unit 
  1. → When removing and installing the steering column switch, turn the steering wheel so that the wheels are in straight-ahead position. This ensures that the airbag contact unit is locked in the central position.
  2. → Do not trap the cable of the airbag contact unit.
  3. → Check that the cable is routed correctly.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Tighten fastening screw to > Tightening - torque 0.5 Nm (0.3 ftlb.)  .