Installing (Rear) PDCC Control Unit
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening screw securing ground line to (rear) PDCC control unit to > Tightening torque 5.6 Nm (3.8 ftlb.) .
Tighten fastening screws securing (rear) PDCC control unit to bracket to > Tightening torque 6 Nm (4.5 ftlb.)
Tighten fastening nuts securing heat shield to holder to > Tightening torque 2.5 Nm (1.75 ftlb.)
Tighten fastening nuts securing holder with (rear) PDCC control unit to the body to > Tightening torque 4 Nm (3 ftlb.)