Supporting Engine On The Body (Engine Safety Device)

Information 

Work on one side of the vehicle is described here; the same work must be carried out on the other side.

1. Remove holder -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Holder for front cover

   1. 1.1  Pull locking pin of the expansion rivet -2-  up and out using a suitable tool and unclip expansion rivet -2-  .
   2. 1.2  Remove holder -1-  .
2. Prepare > 10-222A - support bracket  .
   1. 2.1  Attach two spindles to > 10-222A - support bracket  .
   2. 2.2  Attach supports 10-222 A/1  at the left and right to > 10-222A - support bracket  . Fit the screws so that the supports 10-222 A/1  can still be turned and moved.

   Information 

   The position of the engine transport eyebolts can vary depending on the engine variant.

3. > 10-222A-Support bracket-1-  must now be attached to the vehicle.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Engine safety device

   1. 3.1  Position supports 10-222 A/1 -2-  on the upper longitudinal members by moving them at the slot in the > 10-222A - support bracket-1-  .
   2. 3.2  Check that the supports 10-222 A/1 -2-  are fitted correctly on the upper longitudinal members, tighten screws hand-tight and secure supports using 10-222 A/34. 
   3. 3.3  Hook in hooks -4-  on the engine transport eyebolts and pre-tension spindles -3-  slightly.
   4. 3.4  Check again that the supports 10-222 A/1 -2-  are fitted correctly.
4. Carry out the required work on the vehicle and remove > 10-222A - support bracket  again.

   Information 

   Work on one side of the vehicle is described here; the same work must be carried out on the other side.

5. Install holder -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Holder for front cover

   1. 5.1  Position holder -1-  .
   2. 5.2  Clip in expansion rivet -2-  and lock it with locking pins.