Install Oil Cooler

WARNING: This page is about a different variant/trim than selected.

Information

Risk of contaminating the lubricating system

Cover open parts of the cylinder head.

Installation is performed in reverse order. Pay particular attention to the following:

Fig 1: Oil Cooler Screws Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence:
1. 1.1 Fit new seal.
2. 1.2 Tighten screws in the sequence -1 to 8- to > Initial tightening 5 Nm (3.5 ftlb.) > Final tightening + 9 Nm (6.5 ftlb.)