Installing Catalytic Converter

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Replace seal on primary catalytic converter/catalytic converter exhaust flange.
2. 1.2 Screws on exhaust bracket:
  > Tightening torque 23 Nm (17 ftlb.)
3. 1.3 Clamp securing catalytic converter to exhaust system:
  > Tightening torque 23 Nm (17 ftlb.)
4. 1.4 Screw on catalytic converter holder:
  > Tightening torque 23 Nm (17 ftlb.)
5. 1.5 New nuts on exhaust flange:
  > Tightening torque 23 Nm (17 ftlb.)