Installing Rear Backrest Cover (1/3-Split Folding Rear Seat)
WARNING: This page is about a different variant/trim than selected.
Information
- Use new cushion rings and engage them in the integrated metal strut of the cover.
- Fasten cover to the padding, starting at the inside.
- Installation is performed in reverse order. Pay particular attiring to the following:
Insert cushion rings using > V.A.G 1634B - Cushion Clip Pliers .
Remove creases on cover for rea, backset (1/3-split folding read seat) using the following tools:
- > 9747 - Wetting-off iron
- > 9747/1 - Knurling iron
- > 9747/2 - Bone burnisher
- > V.A.G 1416 - Hot-Air Blower