Installing Cover For Front Seat

NOTIFICATION 

Risk of damage to cover if excessive heat is applied. 

• Creases in cover 
  1. → If creases have formed, only short partial warming with the hot-air gun is permissible.
  2. → The hot-air temperature of 50°C must always be observed.

Information 

• Use new cushion rings and engage them in the integrated metal strut of the cover. 
• Fasten cover to the padding, starting at the inside. 

1. Installation is performed in reverse order. Pay particular attention to the following:
   • > V.A.G 1634B - Cushion Clip Pliers 
2. If creases have formed, partially heat the affected areas of the cover with the hot-air gun and smooth out the cover using the special tools.
   • > 9747 - Wetting-off iron 
   • > 9747/1 - Knurling iron 
   • > 9747/2 - Bone burnisher 
   • > V.A.G 1416 - Hot-Air Blower