Joining Process

WARNING: This page is about a different variant/trim than selected.

Information

The contact surfaces on the adhesive tape or adhesive pad must remain free of dirt, grease and moisture. Do not touch the contact surfaces.

If adhesive tape or an adhesive pad has to be affixed to a spare part:

Remove first piece of film from adhesive tape or adhesive pad.

Press on adhesive tape or adhesive pad over the entire surface for at least>Time 2 min .

Remove second piece of film from adhesive tape or adhesive pad.

Press spare part with applied adhesive tape or adhesive pad onto body over the entire surface for at least>Time 2 min .

If adhesive tape or adhesive pad is already affixed to spare part on delivery:

Remove film from adhesive tape or adhesive pad.

Press spare part with applied adhesive tape or adhesive pad onto body over the entire surface for at least>Time 2 min .