Installing Front Handle
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in screws for armrest and tighten to > Tightening torque 2.3 Nm (1.6 ftlb.) .
Screw in screws for armrest and tighten to > Tightening torque 2.8 Nm (2.1 ftlb.) .
Screw in screws for armrest and tighten to > Tightening torque 2.3 Nm (1.6 ftlb.) .
Screw in screws for armrest and tighten to > Tightening torque 2.8 Nm (2.1 ftlb.) .
Screw in screws for armrest trim and tighten to > Tightening torque 2.3 Nm (1.6 ftlb.) .