Removing Front Anti-Roll Bar

Information 

The PDCC system can be active when the ignition is switched on (even when the vehicle is stationary). To avoid injury/crushing, only work near the anti-roll bar, lower trailing arm and bellows of the steering gear when the ignition is switched off and always allow for the run-on time of 60 seconds.

1. Disconnect electric wire harness for anti-roll bar -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Routing of electric wire harness for anti-roll bar (shown on V6 biturbo)

   1. 1.1 Unclip line clips -2-  .
   2. 1.2 Unclip clip -3-  .
   3. 1.3 Release and disconnect electric plug connection (signal connector) -4-  .
   4. 1.4 Release and disconnect electric plug connection (engine phase connector) -5-  .
   5. 1.5 Unscrew nut on ground line -6-  .
   6. 1.6 Guide electric wire harness for anti-roll bar -1-  out towards the anti-roll bar and out of the wheel housing, but do not disconnect it from the anti-roll bar.
2. Remove front anti-roll bar -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Front anti-roll bar - PDCC

   1. 2.1 Unscrew screws on anti-roll bar clamps -3-  and remove anti-roll bar clamps -2-  .
   2. 2.2 Guide anti-roll bar -1-  down out of the vehicle.