Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Wheel bearing to wheel bearing housing | Internal serration screw, M12 x 42/always replace screws following removal! | Initial tightening | 80 Nm (59 ftlb.) | ||
| Wheel bearing to wheel bearing housing | Internal serration screw, M12 x 42/always replace screws following removal! | Final tightening | + 90° | ||
| Drive shaft to wheel hub | Shouldered bolt, M16 x 1.5 x 72/always replace bolts following removal! | Initial tightening | 200 Nm (148 ftlb.) | ||
| Drive shaft to wheel hub | Shouldered bolt, M16 x 1.5 x 72/always replace bolts following removal! | Final tightening | + 180° | ||
| Upper trailing arm to wheel bearing housing | Hexagon-head bolt, M10 x 130 and hexagon nut | Tightening torque | 40 Nm (30 ftlb.) |