Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw for line bracket on front axle carrier | Item 2 | Tightening torque | 8 Nm (5.9 ftlb.) | ||
|
Wiring holder |
|||||
| Bolt support bearing on front axle carrier | M8 x 45 | Torque | 20 Nm (14.8 ftlb.) | ||
| Front axle carrier on front body | Item 2: M12 hexagon-head bolt x 1.5 x 90/Always replace screws following removal! | Initial tightening torque | 115 Nm (84.8 ftlb.) | ||
| Front axle carrier on front body | Item 2: M12 hexagon head bolt x 1.5 x 90/Always replace bolts following removal! | Final tightening torque | + 90° | ||
| Front axle carrier on rear body | Item 3: M14 hexagon-head bolt x 1.5 x 100/Always replace screws following removal! | Initial tightening torque | 130 Nm (95.9 ftlb.) | ||
| Front axle carrier on rear body | Item 3: M14 hexagon head bolt x 1.5 x 100/Always replace bolts following removal! | Final tightening torque | + 180° | ||
| Longitudinal member on front axle carrier | Item 2 and 6: M6 hexagon-head bolt x 20 | Tightening torque | 10 Nm (7.4 ftlb.) | ||
| Slide of longitudinal member | Item 3: M8 hexagon-head bolt x 75 | Tightening torque | 25 Nm (18.4 ftlb.) | ||
| Longitudinal member on lock support panel | Item 5: M8 internal multipoint screw x 25 | Tightening torque | 23 Nm (17 ftlb.) | ||
| Heat insulation on front axle carrier | Hexagon-head bolt M6 x 16 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Heat insulation to longitudinal chassis beam | Hex bolt M6 x 12/applies to one-piece heat insulation. | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to heat insulation (lower part) | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to longitudinal chassis beam | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| steering column lower part on power steering (universal joint) | Item 2: Internal multitooth screw M8 x 30/Always replace screw following removal! | Initial tightening | 20 Nm (14.8 ftlb.) | ||
| Steering column lower part to power steering (universal joint) | Item 2: Internal multitooth screw M8 x 30/replace screw after every removal! | Final tightening | + 90° | ||
|
Universal joint for power-steering/steering column lower part |
|||||
| Engine mount bolt on engine support | M12 x 1.5 x 70/replace | Initial tightening | 90 Nm (66.4 ftlb.) | ||
| Engine mount bolt on engine support | Final tightening | + 90° | |||