Further To 3: Fitting The Wheel On The Vehicle
WARNING: This page is about a different variant/trim than selected.
Fit wheel using a suitable commercially available tool
Information
- Never use an impact bolter.
- Observe the description on wheel removal and installation (fitting wheel on vehicle)
- Fit the wheels with the lowest residual imbalance values on the front axle. Observe the rolling direction of the wheels.
Fit wheel bolts and tighten uniformly. Start at the top when tightening. Always observe the specified tightening torque.
Set required tyre pressure (tyre-pressure plate).
Balancing weights
Balancing weights: For balance stick-on weights, see Spare Parts Information.
Only zinc weights must be used. These must not be broken or cut.
Attach both weights to the inner side.
Balancing weights
Information
- Observe program selection and operating instructions of the balancing machine.