Installing Pedestrian Protection Sensor
WARNING: This page is about a different variant/trim than selected.
Information
If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be supplied with a barcode sticker (tear-off label).
Tear-off label shown on airbag sensor for example
Tear-off label
- Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the Warranty and Maintenance booklet .
- The replacement date and mileage must be documented and the booklet must be stamped with the dealer's stamp .
Information
To prevent malfunctions, make sure not to kink or pinch the hose during removal and installation.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening screws to > Tightening torque 6 Nm (4.5 ftlb.) .