General Information

WARNING: This page is about a different variant/trim than selected.

WARNING: Improper handling of airbag units

Triggering of airbag unit .
System faults can occur .
1. → Switch off ignition and keep transmitter key outside of the transmission range (at least 2 m).
2. → A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.
3. → Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.
4. → Wait 1 minute after disconnecting the battery.
5. → Only pull off connector on the triggering unit after the waiting time has elapsed.
6. → Make sure that no foreign objects are located in front of the airbag unit during installation.
7. → Replace damaged parts during removal.
8. → Always position airbag units so that the blow-out opening is facing upwards, e.g. crest on driver's airbag.
9. → Do not place any objects on the airbag units.
10. → If removed for an extended period, the airbag units must be stored in a safe place.
11. → Airbag units must not come into contact with grease, oil, detergents, liquids or similar substances.
12. → Do not expose airbag units to temperatures of more than 90°C.
13. → Do not remove the short-circuit spring on the plug contacts.
14. → Triggering and preparations may only be carried out by skilled staff, supervised by a second responsible person.
15. → Before disposal, the airbag unit must be rendered harmless by triggering it electrically while observing all precautionary measures, thereby preventing it from being used incorrectly.

WARNING: Incorrect handling of safety bolts

Danger of injury
Loss of torque
1. → Always use new screws or nuts following removal.
2. → Comply with instructions for repairs.
3. → Observe specified tightening torques.
4. → Carry out a visual inspection of parts used.

Information

Observe the following specifications for all the work described:

Country-specific, national, legal and official regulations,
Local restrictions and export restrictions,
Manufacturer specifications from component and vehicle manufacturers,
Component-specific specifications.

These strict specifications apply in particular to:

Storage, installation and removal, transport and disposal of vehicles, assemblies, operating materials and auxiliary materials,
Handling defective and potentially hazardous vehicles as well as assemblies,
Handling battery electric vehicles and high-voltage components.

Consider relevant and qualified sources of information such as local authorities, competent importer, associations and specialized websites for this purpose. Only deliver items to be disposed of to authorized reception points.

These regulations to be complied with have to be checked, observed and, if necessary, documented by the person responsible for the vehicle for all life phases and work.