Removing Rear Three-Point Belt
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of seat-belt pretensioner unit
- Triggering of seat-belt pretensioner unit
- → Observe safety regulations for handling seat-belt pretensioner units.
> 6X00IN HANDLING AND REPLACING AIRBAG AND SEAT-BELT PRETENSIONER UNITS
- → Observe disposal regulations for seat-belt pretensioner units.
> 6X00IN DISPOSAL OF AIRBAG AND SEAT-BELT PRETENSIONER UNITS
- → After disconnecting the battery, wait 1 minute before disconnecting the seat-belt pretensioner unit.
- → Remove ignition key and disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier is avoided.
> 2706IN00 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- → If removed for an extended period, the seat-belt pretensioner unit must be stored in a safe place.
- → Transport the seat-belt pretensioner unit in such a way that the seat belt can retract safely if it is actuated.
- → Observe safety regulations for handling seat-belt pretensioner units.
- Release and unplug electric plug connection -1-
.
Electric plug connection
Information
Always replace screws on the three-point seat belt. Micro-self-locking screws must not be treated (greased) or loosened and then screwed on again.
- Unscrew fastening screw -2-
and loosen deflection roller.
Fastening screw for deflection roller
Information
Always replace screws on the three-point seat belt. Micro-self-locking screws must not be treated (greased) or loosened and then screwed on again.
- Unscrew fastening screw -1-
.
Fastening screw
- Remove rear three-point belt.
Rear three-point belt