Removing Front Three-Point Belt
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of seat-belt pretensioner unit
- Triggering of seat-belt pretensioner unit
- → Observe safety regulations for handling seat-belt pretensioner units.
> 6X00IN HANDLING AND REPLACING AIRBAG AND SEAT-BELT PRETENSIONER UNITS
- → Observe disposal regulations for seat-belt pretensioner units.
> 6X00IN DISPOSAL OF AIRBAG AND SEAT-BELT PRETENSIONER UNITS
- → After disconnecting the battery, wait 1 minute before disconnecting the seat-belt pretensioner unit.
- → Remove ignition key and disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier is avoided.
> 2706IN00 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- → If removed for an extended period, the seat-belt pretensioner unit must be stored in a safe place.
- → Transport the seat-belt pretensioner unit in such a way that the seat belt can retract safely if it is actuated.
- → Observe safety regulations for handling seat-belt pretensioner units.
- Move driver's seat and passenger's seat fully forward and up.
- Loosen battery ground strap.
> 978509 LOOSENING AND SECURING GROUND STRAP FOR BATTERY
Information
Always replace screws on the three-point seat belt. Micro-self-locking screws must not be treated (greased) or loosened and then screwed on again.
- Remove front three-point belt.
- 3.1
Release and unplug electric plug connections -1-
.
Electric plug connections
- 3.2
Unscrew fastening screw -1-
and loosen seat belt mount.
Fastening screw
- 3.3
Disengage belt guide -1-
.
Seat-belt guide
- 3.4
Unscrew fastening screw -2-
and remove belt deflector.
Fastening screw
- 3.5
Unscrew fastening screw -3-
.
Fastening screw
- 3.6
Remove three-point seat belt -4-
.
Three-point seat belt
- 3.1
Release and unplug electric plug connections -1-
.