Installing Front Three-Point Belt
WARNING: This page is about a different variant/trim than selected.
Information
Do not twist the three-point seat belt during installation.
Information
Once the screw has been tightened, the belt deflector must level out on its own in a vertical position or in the relevant support direction.
Information
Route electric lines outside of the belt roll-up area.
Information
Always replace screws on the three-point seat belt. Micro-self-locking screws must not be treated (greased) or loosened and then screwed on again.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .
Screw in fastening screws and tighten to > Tightening torque 40 Nm (30 ftlb.) .