Installing Cover For Tray

WARNING: This page is about a different variant/trim than selected.

Insert guides -1- into the cut-outs on the centre console.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Guides
Guide inner guide -1- over the front locating peg.
Make sure that the bore in the base of the cover is above the front locating peg -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Inner guide
The remaining installation steps are performed in reverse order. Pay particular attention to the following:
Tightening torque for screws on cover for tray. > Tightening torque 20 Nm (15 ftlb.)