Installing Vehicle Electrical System Battery (Lithium-Ion Battery)
WARNING: This page is about a different variant/trim than selected.
Observe specifications for handling 12-volt lithium-ion batteries.
> 2X00IN Specifications for handling 12 V/48 V lithium-ion batteries
- Installation is performed in reverse order. Pay particular attention to the following:
Screw on fastening nuts for retaining bar and tighten to > Tightening torque 25 Nm (19 ftlb.) .
Secure positive terminal clamp and tighten to > Tightening torque 5 Nm (3.5 ftlb.) .
Secure ground terminal clamp and tighten to > Tightening torque 5 Nm (3.5 ftlb.) .
Battery ventilation must engage securely.