Assembling Front Lid
WARNING: This page is about a different variant/trim than selected.
Information
Information about the painting process can be found in the Paint Information.
- Paint the front lid.
- Install front lock upper parts.
- Clip in seal.
- Install front logo.
- Install insulation for engine compartment lid.
> 700419 REMOVING AND INSTALLING INSULATION FOR ENGINE COMPARTMENT LID
Information
- Carefully clean body in the installation area with isopropanol to remove any dirt.
- Always use a clean, lint-free cloth.
- The room and object temperature must be at least +15°C.
- Humidity must be 50% +/- 10%.
- The parts must have been bonded for at least 72 hours before washing the vehicle in a car wash.
- Affix all stickers that were on the old lid on the new lid.