Installing Pressure Pipe (On Turbocharger)
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Tighten screws securing pressure pipe to turbocharger.
> Tightening torque 9 Nm (6.5 ftlb.)
- 1.2
Tighten screw-type clamp on connecting tube for pressure pipes.
> Tightening torque 5.5 Nm (4 ftlb.)
- 1.3
Tighten screw-type clamps securing pressure hose to pressure pipe.
> Tightening torque 5.5 Nm (4.1 ftlb.)