LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (21 Exhaust Gas Turbocharging 4.0L -- 9YA - Cayenne (9YA)) >> WM, 214119 Remove And Install Pressure Pipe (V8 BITURBO) >> Install Pressure Pipe >> Installing Pressure Pipe (On Charge-Air Cooler)

Installing Pressure Pipe (On Charge-Air Cooler)

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screws securing pressure pipe to charge-air cooler.

      > Tightening torque 8 Nm (6 ftlb.) 

    2. 1.2  Tighten screw-type clamp securing pressure hose to pressure pipe.

      > Tightening torque 5.5 Nm (4.1 ftlb.) 

scientia non olet · About LEMON Manuals