LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (24 Fuel System - Electronic Injection 4.0L -- 9YA - Cayenne (9YA)) >> WM, 244220 Removing And Installing Throttle Housing (V8 BITURBO) >> Installing Throttle Housing >> Installing Right Throttle Housing

Installing Right Throttle Housing

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tighten screws securing coolant pipe for coolant regulator housing to crankcase.

    > Tightening torque 8 Nm (6 ftlb.) 

    Tighten screws securing right throttle housing to intake-air distributor.

    > Tightening torque 7 Nm (5 ftlb.) 

scientia non olet · About LEMON Manuals