Installing Rear-View Mirror Housing (Upper Part)
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws -1-
on rear-view mirror housing to > Tightening torque 1.4 Nm (1 ftlb.)
.
Tighten screw -2-
on rear-view mirror housing to > Tightening torque 0.9 Nm (0.7 ftlb.)
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Screws