Installing Rear Spoiler

Information 

Check fixing clips, retaining clips and expanding clips for damage and replace them if necessary.

Check that all fixing clips, retaining clips and expanding clips are fitted at the correct position.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Before fitting the rear spoiler in the guides, clip in antenna line and install rubber sleeves.

   Screw on fastening nut and tighten to > Tightening torque 6 Nm (4.5 ftlb.)  .

   Screw in fastening screws and tighten to > Tightening torque 6 Nm (4.5 ftlb.)  .

   Screw in fastening screws and tighten to > Tightening torque 6 Nm (4.5 ftlb.)  .