Replacing Rear Logo
WARNING: This page is about a different variant/trim than selected.
- Heat the area around the rear logo using > V.A.G 1416 - Hot-Air Blower .
- Prise off rear logo using a plastic spatula.
- Remove adhesive residue from around the rear logo using silicone remover.
Information
- Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol .
- Always use a clean cloth .
- The room and object temperature must be at least > Nominal value + 15°C .
- Air humidity must be > Nominal value 50 % +/- 10 % .
- Do not touch the bonding surface again after removing the protective paper .
- Wear clean gloves during the bonding process in order to guarantee adequate adhesion .
- The parts must have been bonded for at least > Nominal value 72 h before washing the vehicle in a car wash .
- Position logo rear using logo template and interchangeable insert.
> 9967 - Logo template "Cayenne"
> 9967/1 - Logo template "Cayenne" e-hybrid
> 9967/2 - Logo template "Cayenne S"
> 9967/3 - Logo template "Cayenne turbo"
> 9967/4 - Logo template "Cayenne turbo S"
> 9967/5 - Logo template "Cayenne GTS"
> 9977 - Logo template "Cayenne" (Coupe)
> 9977/1 - Logo template "Cayenne S" (Coupe)
> 9977/2 - Logo template "Cayenne turbo" (Coupe)
> 9977/3 - Logo template "Cayenne" e-hybrid (Coupe)
> 9977/4 - Logo template "Cayenne turbo S" (Coupe)
> 9977/5 - Logo template "Cayenne GTS" (Coupe)
> 9977/6 - Logo template "turbo GT" Cayenne (Coupe)