Installing Rear Wheel Cover (Sport Design)

Information 

Check fixing clips, retaining clips and expanding clips for damage and replace them if necessary.

Check that all fixing clips, retaining clips and expanding clips are fitted at the correct position.

Installation is performed in reverse order. Pay particular attention to the following:

1. Prepare bonding surfaces for adhesive tapes.

   > 6X00IN30 WORKING WITH ADHESIVE TAPE AND ADHESIVE PADS

2. Tighten screws securing rear wheel cover (Sport Design) to body using > Tightening torque 1.5 Nm (1 ftlb.)  .
3. Tighten nuts securing rear wheel cover (Sport Design) to body using > Tightening torque 2.5 Nm (1.75 ftlb.)  .