Installing Rear Wheel Cover
WARNING: This page is about a different variant/trim than selected.
Information
Check fixing clips, retaining clips and expanding clips for damage and replace them if necessary.
Check that all fixing clips, retaining clips and expanding clips are fitted at the correct position.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten screws securing rear wheel cover to body to > Tightening torque 1.5 Nm (1 ftlb.) .
- Tighten nuts securing rear wheel cover to the body to > Tightening torque 2.5 Nm (1.75 ftlb.) .