Installing The Front Wheel Cover (Sport Design)
WARNING: This page is about a different variant/trim than selected.
Installation is performed in reverse order. Pay particular attention to the following:
- Prepare bonding surfaces for adhesive tapes.
> 6X00IN30 WORKING WITH ADHESIVE TAPE AND ADHESIVE PADS
Information
Check fixing clips, retaining clips and expanding clips for damage and replace them if necessary.
Check that all fixing clips, retaining clips and expanding clips are fitted at the correct position.
- Tighten screws to > Tightening torque 1.5 Nm (1 ftlb.) .