LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (10 Engine - Crankcase, Suspension 2.9L -- 9YA - Cayenne (9YA)) >> WM, 103519 Removing And Installing Engine Mount (Supporting Mount) (V6 Turbo) >> Installing Engine Mount (Supporting Mount) >> Installing Supporting Mount

Installing Supporting Mount

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screw securing supporting mount to front-axle carrier.

      > Torque 20 Nm (14.8 ftlb.) 

    2. 1.2  Tighten screws securing supporting mount to engine mount bracket.

      > Torque 10 Nm (7.4 ftlb.) 

scientia non olet · About LEMON Manuals