Subsequent Work - V6 Monoturbo
WARNING: This page is about a different variant/trim than selected.
- Install pressure pipe at the turbocharger.
> 214119 REMOVING AND INSTALLING PRESSURE PIPE (V6 MONOTURBO)
- Install the centre intake-air distributor.
> 244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR (V6 TURBO)
- Install the drive belt.
> Refer to the appropriate service information.
- Fill in coolant and bleed the cooling system.
> Refer to WM, 193817 DRAINING AND FILLING COOLANT (LOW-TEMPERATURE COOLING SYSTEM) / WM, 193817 DRAINING AND FILLING COOLANT (HIGH-TEMPERATURE COOLING SYSTEM)