Install Centre Intake Distributor

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Check sealing rings for centre intake distributor at the intake-air distributor and replace them if damaged.
2. 1.2 Tighten screws on holder for centre intake distributor.
  > Tightening torque 8 Nm (6 ftlb.)
3. 1.3 Tighten screws securing centre intake distributor to side intake distributors.
  > Tightening torque 7 Nm (5 ftlb.)