LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (63 Bumper (Wagon) -- 9YA - Cayenne (9YA)) >> WM, 631519 - Removing And Installing Front Bumper >> Installing Front Bumper >> Installing Front Apron

Installing Front Apron

WARNING: This page is about a different variant/trim than selected.

Information 

During installation, make sure that all locking lugs are positioned correctly and have engaged fully. Use a suitable tool to help if necessary.

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tighten fastening screws on top of wing to > Tightening torque 2.5 Nm (1.75 ftlb.)  .

    Tighten fastening screws on lower front end to > Tightening torque 4.5 Nm (3.25 ftlb.)  .

    Tighten fastening screws on upper front end to > Tightening torque 3 Nm (2 ftlb.)  .

scientia non olet · About LEMON Manuals