Installing Supply Line - Section From Underbody To Engine
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten nuts on cover in front right wheel housing.
> Tightening torque 4.5 Nm (3.25 ftlb.)
- 1.2
Tighten screws/nuts for heat shields on underbody.
> Tightening torque 2.5 Nm (1.75 ftlb.)
- 1.1
Tighten nuts on cover in front right wheel housing.