Installing Brake Booster
WARNING: This page is about a different variant/trim than selected.
Information
Fit the vacuum line before connecting the brake booster and brake pedal.
Information
The brake booster must not be handled in the input rod/bellows area.
Information
Always replace brake boosters on which the push rod has pushed past the brake pedal clip and the screws have been tightened to their final tightening torque.
Information
The stoppers must not be removed until immediately before guiding on the brake pressure lines.
Information
Make sure not to get the brake lines mixed up.
- Installation is performed in reverse order. Fay particular attention to the following:
- 1.1
Tighten screws securing brake booster to the body.
> Tightening torque 25 Nm (19 ftlb.)
- 1.1
Tighten screws securing brake booster to the body.