Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Brake calliper to wheel bearing housing | M12/always replace screws or bolts following removal! | Initial tightening | 30 Nm (22 ftlb.) | ||
| Brake calliper to wheel bearing housing | M12/always replace screws or bolts following removal! | Final tightening | + 75° | ||
| Brake line to brake calliper | Union nut, M10 x 1 | Tightening torque | 14 (10.5 ftlb.) Nm | ||
| Brake line holder to rear-axle brake calliper | Cheese head bolt, M6 x 16 | Tightening torque | 10 Nm (7.5 ftlb.) |