Installing Belt TENSIONER (Generator)
WARNING: This page is about a different variant/trim than selected.
Information
Loosen belt tensioner slowly and in a controlled manner because otherwise oil can leak out via the bellows.
Information
- Replace screws.
Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screw securing belt tensioner (generator) to crankcase.
> Initial tightening 8 Nm (6 ftlb.)
> Final tightening + 45°
Screw in and tighten screw securing belt tensioner (generator) to crankcase.
> Tightening torque 32 Nm (24 ftlb.)
> Tightening torque 32 Nm (24 ftlb.)